Installing a new motorcycle seat cover is easy when you know how. You just need a few basic tools, a little patience and then apply the below 3 easy steps. With the new cover fitted, your dirt or road bike will look better that ever in no time.

 

 

Tools Required:

 

 

 

Start off by removing existing seat cover. Ensure all existing staples are removed by using flat blade screw driver to lever up the middle of staples and pliers to pull out any stuck staples.

 

 

 

Start from the front and whilst pulling the seat cover taut install two to three staples at the nose of the seat. Repeat this action with the rear of the seat. Once front and rear have been stapled concentrate on the middle of the seat pulling the cover taut throughout the process before stapling. Tip: Staple approximately every 15mm until the seat cover is secured and completely stapled down.

 

 

 

Once seat cover has been completely secured and stapled down use a stanley knife to trim off any excess seat cover material that is over hanging. Ensure at least 15 -20mm of material is remaining so staples have enough material to grip.

 

To check out the full range of Strike Seat Covers click here.

 

We also have a new range of replacement motorcycle Strike Seat Foams available here.